We are Dealership auto mechanics with over 40 years experience.
On this website you will find car repair answers, pictures, forums and information.


Browse our free car repair help in our-
latest answers


ProTech’s Corner – Read the blog from the daily life or a REAL Dealership Technician. Get the inside scoop on what really goes on at the Dealership- behind the scenes. Mechanics are real people who have a career just like you. His information is through his eyes, honest, real and sometimes raw. We dare you to find anywhere on the Web the truthful, unbiased and behind the scenes stories of what goes on at the Dealership.


Browse our ask questions in our-
Car repair Forums


Some Recent Car Questions And Answers:

  • How To Install Buick Century Power Steering Pump I have a 2004 Buick Century and I need to see a picture of how the power steering sits. My nephew tore apart the engine. I know how to replace it but the issue is that I don’t know what bolts go where or if the unit is set right. Mechanic JK: What engine size in your Buick? I believe 3100. OK. ...
  • Should I Use Factory Repacement Parts in my Car? A lot of people are under the assumption that parts are parts, and getting the lowest price on a certain part for your vehicle is key in deciding what or where to buy. This is about as far from the truth as possible. As a rule of thumb, and as many cases in life agree, ...
  • Engine Has No Oil Pressure To Lifters Or Rocker Arms I am having problems with a 2009 Chevy GMC 8.1 engine. The rocker system is not oiling. What causes this and how can I fix it? Do you have an oil pressure gauge on the dash? Yes we hooked 1 up 50 pound of pressure idling. 50 PSI at idle is quite high on this motor hot. ...
  • 1998 Mazda 626 Failed Smog Test With Code P0455 I am having to fix a Mazda 626 1998 EVAP gross gas leak, can you help me? ProTech: I sure can try…what seems to be the trouble? Smog failed test, a EVAP system gas leak. Things that usually cause a large EVAP leak are a loose or bad gas cap, a stuck open vent valve, a bad purge solenoid, or ...
  • 2004 Chevy Malibu Thermostat – Transmission Problems I changed my transmission fluids out on a 2004 Chevy Malibu and the pan keeps on leaking and I put sealer on the rubber tabs but it would not stop. ProTech: Do NOT use any sealer on the trans pan or gasket area, that will just make matters worse. You need to get a good GM trans ...
  • 2001 Chevrolet Cavalier Trac Off and Engine Light Well my car is dead and it won’t start. The Trac off light came on and the check engine light and the battery light and the oil light came on and when I went to step on the gas pedal it wouldn’t increase speed. It is a 2001 Chevy Cavalier. Does the engine crank over when ...
  • Nissan Altima Heater blowing cold air all the time I have a 2003 Nissan Altima a couple of days ago the car over heated we drove it less than 2 minutes and put coolant in it. It was bone dry but we filled it up well ever since then my car has been acting crazy. Ever since then my car was been having steam/smoke ...
  • 2000 Saturn Has Engine Noise and No Oil In It My 2000 Saturn SL2 is making noises when I accelerate. I took it in today to get an oil change and it was bone dry. What can I do to prevent loss of the car? I am afraid there is engine damage. ProTech: Well, if it went long enough without oil, you could have done permanent engine ...
  • 1993 Lexus At A Good Price- Is It Worth The Money? Hi, i’m looking buying a 1993 lexus ls400. It’s going to be my first car and it’s at a good price right now. Only problem is, it has 273,000 miles on it. Is this too much of a gamble considering the transmission might need to be replaced? I know Lexus are supposed to be reliable ...
  • 2005 Chevy Equinox heat air problem My 05 equinox heat/air was blowing perfect, and then slowly started to stop, coming on sometimes when I would turn the middle knob, until stopping completely. We replaced the resistor, but that did not fix it. Answer: If you mean the fan is blowing fine, but the air temperature looses heat, then this is not a ...

Leave comments below or see these